t1unmac Man page

T1UNMAC(1) General Commands Manual T1UNMAC(1)


t1unmac – translate a Mac PostScript Type 1 font into PFA or PFB format


t1unmac [-a|-b] [-r] [input [output]]


t1unmac extracts POST resources from a Macintosh PostScript font file
and creates a PFA (hexadecimal) or PFB (binary) font file. The file
input should be in MacBinary I or II, AppleSingle, AppleDouble, or Bin‐
Hex format, or it can be a raw resource fork. If the file is a raw
resource fork, you need to give the `–raw’ option; otherwise t1unmac
should automatically figure out what kind of file you have. If the file
output is not specified output goes to the standard output.


–pfa, -a
Output in PFA (ASCII) format.

–pfb, -b
Output in PFB (binary) format. This is the default.

–raw, -r
Indicates that the input is a raw resource fork.

Indicates that the input is in MacBinary I or II format.

Indicates that the input is in AppleSingle format.

Indicates that the input is in AppleDouble format.

Indicates that the input is in BinHex 4.0 format.

–block-length=num, -l num
PFB only: Set the maximum output block length to num. The default
length is as large as memory allows.

–line-length=num, -l num
PFA only: Set the maximum length of encrypted lines in the output
to num. (These are the lines consisting wholly of hexadecimal
digits.) The default is 64.

On Mac OS X, you can use t1unmac to translate a font into PFA or PFB
format as follows:
% t1unmac –raw FONTFILENAME/..namedfork/rsrc > OUTPUT


t1mac, t1ascii, t1binary, t1asm, t1disasm

Lee Hetherington (ilh@lcs.mit.edu)
Eddie Kohler (ekohler@gmail.com)

Ported to Microsoft C/C++ Compiler and MS-DOS operating system by Kai-
Uwe Herbing (herbing@netmbx.netmbx.de).

Version 1.39 T1UNMAC(1)

Ils en parlent aussi